Instrukcja Thomson ROC1128SAM Pilot telewizyjny

Instrukcja

4 5

GB

GB

2. Then press and release the target key on

the remote control you want learned.

3. If the LED ashes 3times and then remain

on, the command has been learned

successfully.

4. Repeat these steps to learn other key

functions.

5. Press the [MUTE] and [VOL-] buttons to

save all learnt functions and to exit the

learning mode.



While replacing the batteries, the remote control

will keep the functions of the learned keys.

    

     

1. Press and hold [MUTE] and [VOL+] keys

for 5seconds until the LED will be lit.

5

2. Enter the code [9] [8] [1], the LED will

ash 2times and then remain on.

3. Press and release the desired key at the

replacement remote control which you

want to clear the learned command. If the

LED ashes 3times, the learned command

has been cleared successfully.

     

1. Press and hold [MUTE] and [VOL+] keys for

5seconds until the LED will be lit.

5

1. Enter the code [9] [8] [2], the LED will ash

2times and then remain on.

2. Press and release the [OK] key at the

replacement remote control. If the LED

ashes 3times, all commands have been

cleared successfully.

  

This remote control is equipped with an 

.Thus you could reduce the functionality of

the remote control to its basic functions. It avoids

that the TV Settings arechanged by mistake.

During the   you still could use

following keys:

POWER TV ON /OFF

 Change your TV‘s volume

TV Mute

 Channel up/down

 Numeric keys 0–9toenter channel

numbers



Teletext ON /OFF /MIX

Use to select avariety of on screen

options

 Show the Electronic Program Guide

(if supported by the TV)

Input signal source /Indicator LED

Turn off the menu of the selected

product

 Switch to signal source TV

   

1. Press and hold [MUTE] and [VOL+] keys for

5seconds until the LED will be lit.

5

2. Enter the code [9] [7] [0], the LED will ash

two times and then remain on.

3. Press and release the [OK] key,ifLED ash

3times, you have entered the 

 successfully

   

1. Press and hold [MUTE] and [VOL+]

for 5seconds until the LED will be lit.

5

2. Enter the code [9] [7] [0], the LED will ash

two times and then remain on.

3. Press and release the [EXIT] key,ifLED

ash 3times, you have exit the 

.



While the   is activated only

the keys mentioned in chapter 7. will work.

If one of these keys is pressed the LED will

be lit until the key is released. If one key is

pressed during the normal mode, the LED

will ash.

 

•Donot mix new and used batteries for

powering the Universal Remote Control, as

old batteries tend to leak and may cause

power drain.

•Donot use corrosive or abrasive cleansers on

your Universal Remote Control.

•Keep the Universal Remote Control dust free

by wiping it with asoft, dry cloth.

 

Q. My Universal Remote Control does not

work at all!

A. Check your TV. If the TV main switch is

turned off, your Remote cannot operate

your TV.

A. Check whether your batteries are inserted

properly and are in the correct +/- position.

A. If the batteries are low, replace the

batteries.

Q. My TV responds only to some of the

commands.

A. Try other codes until most keys work

properly.

Q. Some keys of the Remote Control do not

work anymore?

A. Maybe the   had been

activated. Deactivate the   as

explained in chapter 7.2.

  

The manufacturer assumes no liability and

provides no warranty for damage resulting

from improper installation/mounting, improper

use of the product or from failure to observe

the operating instructions and/or safety notes.

   

Please contact Hama Product Consulting if you

have any questions about this product.

Hotline: +49 9091 502-115 (German/English)

Further support information can be found here:

www.hama.com

  

  



After the implementation of the

European Directive 2012/19/EU and

2006/66/EU in the national legal

system, the following applies: Electric and

electronic devices as well as batteries must not

be disposed of with household waste.

Consumers are obliged by law to return

electrical and electronic devices as well as

batteries at the end of their service lives to the

public collecting points set up for this purpose

or point of sale. Details to this are defined by

the national law of the respective country. This

symbol on the product, the instruction manual

or the package indicates that aproduct is

subject to these regulations. By recycling,

reusing the materials or other forms of utilising

old devices/Batteries, you are making an

important contribution to protecting our

environment.

Ocena

Więcej o tej instrukcji

Rozumiemy, że miło jest mieć papierową instrukcję obsługi Thomson ROC1128SAM Pilot telewizyjny. Zawsze możesz pobrać instrukcję z naszej strony internetowej i wydrukować ją samodzielnie. Jeśli chcesz otrzymać oryginalną instrukcję, zalecamy skontaktowanie się z Thomson. Być może będą w stanie dostarczyć oryginalną instrukcję. Szukasz instrukcji swojego Thomson ROC1128SAM Pilot telewizyjny w innym języku? Wybierz preferowany język na naszej stronie głównej i wyszukaj numer modelu, aby sprawdzić, czy jest on dostępny.

Dane techniczne

Wszystkie podręczniki dla Thomson Pilot telewizyjny
Więcej podręczników Pilot telewizyjny

Często zadawane pytania dotyczące Thomson ROC1128SAM Pilot telewizyjny

Nasz zespół wyszukuje przydatne informacje na temat produktu i udziela odpowiedzi na często zadawane pytania. Jeśli znajdziesz nieścisłości lub błędy w naszych odpowiedziach na pytania, poinformuj nas o tym przy pomocy naszego formularza kontaktowego.

Produkty powiązane

Instrukcja

Thomson ROC240 Pilot telewizyjny

Instrukcja

Thomson ROC250 Pilot telewizyjny

Instrukcja

Thomson ROCZ309 Pilot telewizyjny

Instrukcja

Thomson ROC4206 Pilot telewizyjny

Instrukcja

Thomson ROC550 Pilot telewizyjny

Instrukcja

Thomson ROC1117GRU Pilot telewizyjny

Instrukcja

Thomson ROC2309 Pilot telewizyjny

Instrukcja

Thomson ROC5209 Pilot telewizyjny

Powiązane kategorie