Instrukcja Respekta DH520WL Okap kuchenny

Instrukcja

6

hazards.

Do not use with a programmer, timer, separate remote

control system or any other device that switches on

automatically.

This appliance is marked according to the European

directive 2012/19/EC on Waste Electrical and Electronic

Equipment (WEEE). By ensuring this product is disposed of

correctly, you will help prevent potential negative

consequences for the environment and human health,

which could otherwise be caused by inappropriate waste

handling of this product.

The symbol

on the product, or on the documents

accompanying the product, indicates that this appliance

may not be treated as household waste. Instead it should

be taken to the appropriate collection point for the recycling

of electrical and electronic equipment. Disposal must be

carried out in accordance with local environmental

regulations for waste disposal.

For further detailed information regarding the process,

collection and recycling of this product, please contact the

appropriate department of your local authorities or the local

department for household waste or the shop where you

purchased this product.

Appliance designed, tested and manufactured according to:

• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC

62233.

• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3;

ISO 5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC

60704-3; ISO 3741; EN 50564; IEC 62301.

• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-

2; EN/IEC 61000-3-2; EN/IEC 61000-3-3. Suggestions for a

correct use in order to reduce the environmental impact:

Switch ON the hood at minimum speed when you start

cooking and kept it running for few minutes after cooking is

finished. Increase the speed only in case of large amount of

smoke and vapour and use boost speed(s) only in extreme

situations. Replace the charcoal filter(s) when necessary to

maintain a good odour reduction efficiency. Clean the

grease filter(s) when necessary to maintain a good grease

filter efficiency. Use the maximum diameter of the ducting

system indicated in this manual to optimize efficiency and

minimize noise.

Installation

The minimum distance between the supporting surface for

the cooking equipment on the hob and the lowest part of the

range hood must be not less than 50cm from electric

cookers and 65cm from gas or mixed cookers.

If the instructions for installation for the gas hob specify a

greater distance, this must be adhered to.

The template (*) can be used for installation.

Electrical connection

The mains power supply must correspond to the rating

indicated on the plate situated inside the hood. If provided

with a plug connect the hood to a socket in compliance with

current regulations and positioned in an accessible area,

after installation. If it not fitted with a plug (direct mains

connection) or if the plug is not located in an accessible

area, after installation, apply a double pole switch in

accordance with standards which assures the complete

disconnection of the mains under conditions relating to

over-current category III, in accordance with installation

instructions.

Warning! Before re-connecting the hood circuit to the mains

supply and checking the efficient function, always check

that the mains cable is correctly assembled.

Warning! If the supply cord is damaged, it must be replaced

by the manufacturer, its service agent or similarly qualified

persons in order to avoid hazard.

Operation

The hood is fitted with a control panel with aspiration speed

selection control and a light switch to control cooking area

lights.

Maintenance

Clean using ONLY the cloth dampened with neutral liquid

detergent. DO NOT CLEAN WITH TOOLS OR

INSTRUMENTS. Do not use abrasive products. DO NOT

USE ALCOHOL!

Grease filter - Carbon filter (*): it is/they are mounted on

the back of the grill and must be changed once a month.

If the metal fats filter is envisaged in the model in your

possession, this must be cleaned once a month with non-

aggressive detergent manually or in a dishwasher at low

temperature and short cycle.

The metal anti-fats filter might discolour by washing in a

dishwasher but its filtering characteristics do not change at

all.

Changing bulbs (Attention! Make sure that the bulbs are

cool before touching them): Use Ø35mm E14 28W halogen

candle lamps only.

Ocena

Więcej o tej instrukcji

Rozumiemy, że miło jest mieć papierową instrukcję obsługi Respekta DH520WL Okap kuchenny. Zawsze możesz pobrać instrukcję z naszej strony internetowej i wydrukować ją samodzielnie. Jeśli chcesz otrzymać oryginalną instrukcję, zalecamy skontaktowanie się z Respekta. Być może będą w stanie dostarczyć oryginalną instrukcję. Szukasz instrukcji swojego Respekta DH520WL Okap kuchenny w innym języku? Wybierz preferowany język na naszej stronie głównej i wyszukaj numer modelu, aby sprawdzić, czy jest on dostępny.

Dane techniczne

Wszystkie podręczniki dla Respekta Okapy kuchenne
Więcej podręczników Okapy kuchenne

Często zadawane pytania dotyczące Respekta DH520WL Okap kuchenny

Nasz zespół wyszukuje przydatne informacje na temat produktu i udziela odpowiedzi na często zadawane pytania. Jeśli znajdziesz nieścisłości lub błędy w naszych odpowiedziach na pytania, poinformuj nas o tym przy pomocy naszego formularza kontaktowego.

Produkty powiązane

Instrukcja

Respekta CH22059IX Okap kuchenny

Instrukcja

Respekta DH620WL Okap kuchenny

Instrukcja

Respekta DH540IXL Okap kuchenny

Instrukcja

Respekta DH640IXL Okap kuchenny

Instrukcja

Electrolux LFG818W Okap kuchenny

Instrukcja

VDB Smart White 60 Okap kuchenny

Instrukcja

Electrolux LFV336K Okap kuchenny

Instrukcja

Samsung NK36C7070WS Okap kuchenny

Powiązane kategorie