14
English
Examples of measuring using diff erent reference points
1
Measuring using front reference point (Fig. 7)
Place the front (reference point) of the instrument against the
measuring surface.
2
Measuring using rear reference point (Fig. 8)
Place the rear (reference point) of the instrument against the
measuring surface.
3
Measuring using the W1/4 socket hole (for the tripod) as the
reference point (Fig. 9)
Use the center of the socket hole for attaching the tripod as the
reference point.
NOTE
If the instrument needs to be level with the target, adjust the level using
the bubble tube. (Fig. 10)
5. Measuring procedures in each mode
NOTE
○
Check that there is nothing obstructing measurement by the laser.
○
Do not move the instrument during measuring (except during
continuous measurement).
○
The center of the laser beam is measured. The same applies when
the beam is aimed diagonally at the target.
○
The measuring range may vary depending on the characteristics of
the laser beam refl ected from the target surface or the surrounding
brightness.
To measure quickly and accurately outdoors in bright sunlight, use
a target plate (sold separately) or put the target in the shade.
○
Measuring errors may occur with transparent surfaces (such as
glass or water) or mirror surfaces, as well as in the case of surfaces
with holes in, uneven surfaces, diff erent temperatures and indirectly
refl ected light.
○
If the power is turned on and no button is pressed, the power will
turn off automatically after approximately 3 minutes. Press the
power button again to resume operation.
○
If the instrument is used and then left with no button pressed,
the laser will turn off after approximately 30 seconds. Press the
measure button again to resume operation.
○
The length of time after the power is turned on until the instrument is
ready to measure may vary depending on the usage environment.
○
If an error occurs while measuring, remedy the cause before
resuming measuring.
Measuring distance (Fig. 2, 6)
1
Select distance mode. (See “Selecting a measuring mode”)
2
Press the measure button and aim the laser beam at the target. The
status is indicated on the display.
3
Press the measure button again to stop measuring. A beep sounds
and the measurement is indicated on the display. When measuring
is fi nished, the laser goes off .
4
To continue measuring distance, repeat steps
2
and
3
.
The side button on the side of the instrument has the same function
as the measure button on the operation panel.
For convenient operation in narrow spaces, the instrument can be
placed in a vertical position.
Continuous measurement
Use continuous measurement to set the desired position from the
target.
1
Select continuous measurement mode. (See “Selecting a
measuring mode”)
2
Press the measure button and aim the laser beam at the target.
3
Move the instrument until the desired measurement is indicated on
the display.
4
Press the measure button again to fi nish continuous measurement.
The last measurement is indicated on the display.
Measurements are successively indicated on the display with a beep
sound every 0.5 to 3 seconds.
The previous measurement is deleted when the next measurement is
taken.
In continuous measurement mode, the power does not turn off
automatically. Be sure to press the power button after operation to end
continuous measurement.
000BookUG50YEE.indb14000BookUG50YEE.indb142009/08/2012:31:392009/08/2012:31:39
Dołącz do dyskusji na temat tego produktu
Tutaj możesz podzielić się swoją opinią na temat Hitachi UG 50Y Dalmierz laserowy. Jeśli masz pytanie, najpierw dokładnie przeczytaj instrukcję. Zapytanie o instrukcję można złożyć za pomocą naszego formularza kontaktowego.