Instrukcja Bionaire BU4000 Nawilżacz

Instrukcja

2

3

CONGRATULATIONS

By choosing a Bionaire

®

humidifier, you have chosen

one of the finest humidifiers on the market today

READ AND RETAIN THE FOLLOWING

FOR FUTURE REFERENCE.

Note: Carefully remove all securing tapes and

two Water Filters. Keep all packaging for future

storage when humidifier is not in use.

GENERAL DESCRIPTION (SEE FIG. 1)

A Mist Nozzle

B Mist Channel

C Viewing panel

D Airflow outlet

EWater tank support (2)

F Control panel

F1 Power On/Off

F2 Mist Control / Humidity Level Control

G Base

HTransducer (not visible)

IWater basin

JWater level security switch

K Security switch

LWater outlet

MWater Tanks (2)

N Handle

O Filter (2)

IMPORTANT SAFEGUARDS

Please read this manual carefully before using

this appliance, as correct use will give you the

best possible performance.

When using electrical appliances, basic safety

precautions should always be followed, including

the following:

• Read all instructions before using.

• Close supervision is necessary when any

appliance is used near children. Appliance

must be kept out of the reach of children.

• Appliance must be used by a responsible adult.

• Unplug from outlet when not in use, before

putting on or taking off parts, and before cleaning.

• Do not operate any appliance with a

damaged cord or plug, or after the appliance

malfunctions or has been dropped or damaged

in any manner. If the cord is damaged, it

must be replaced by the the manufacturer or

a service agent in order to avoid hazard.

• The use of accessory attachments not

recommended or sold by Bionaire

®

may

result in fire, electric shock or personal injury.

• Do not use outdoors.

• Do not let cord hang over edge of table or

counter, or touch hot surface including the stove.

• Do not use appliance for other than intended use.

• Always disconnect the appliance from the

supply if it is left unattended and before

assembling, disassembling or cleaning.

•In the event of a momentary electrical

disturbance, the product may malfunction

and require user to reset the product.

• Check the operating voltage shown on the

back of the unit. Do not operate at higher

voltage than shown.

•Never turn on, plug in or unplug the

humidifier while your hands are wet in order

to avoid electric shock.

• Ensure humidifier is level. If the humidifier is not

level always turn the power off before handling it.

• Do not disassemble the humidifier while it is

plugged in to avoid electric shocks.

• If you need to replace the plug or cable always

refer to the instructions "Installation of a plug".

• If the supply cord is damaged, it must be

replaced by the manufacturer or its service

agent or a similarly qualified person.

• Do not place humidifier in front of ventilating

outlets and keep away from furniture and

other electrical appliances.

• Do not add water directly into the mist

conductor or nozzle.

ASSEMBLY INSTRUCTIONS

1. Be sure the humidifier is switched off and

disconnected from the wall outlet.

2. Installl the Water Filters into the base.

WARNING: When installing a new Water

Filter, be sure to first remove the plastic bag,

then follow "Filter Use instructions".

IMPORTANT: To eliminate the emission of

minerals from the water, it is recommended

that the Water Filter be used.

3. Position Mist Channel (B) over Base (G),

carefully locate into base, (see Fig 2).

4. Insert the Mist Nozzle (A) onto the Mist

channel (B), (see Fig. 2).

5. Place the water tanks on the base (see Fig. 3).

IMPORTANT: Make sure the water tanks as

well as the water basin are clean before using

the appliance and after storing for a long time.

6. Ensure humidifier is level. If the humidifier is not

level always turn the power off before handling it.

OPERATING INSTRUCTIONS

Fill Water Tanks

NOTE: Be sure the humidifier is switched off

and disconnected from the wall outlet. The water

you put into the water tanks should be clean and not

U.K. and IRELAND

be over 40

°C

. (cold boiled water or demineralised

water are recommended).

1. Remove the water tanks out from the base.

2. Unscrew the water outlet valve (L).

3. Fill the tanks with clean water and screw the

valve back tightly onto the tanks. (See Fig. 4)

4. Put the water tanks back on the base. (see Fig.4).

Switch the Unit On and Off (See Fig. 1 F1)

1. Put the plug into the main supply.

2. Press Power ( ) (F1) to switch on and off

the Ultrasonic Humidifier. The LED screen is

lightened when the power is on.

NOTE: This unit has a memory. The control

panel will remember the previous mist output

level setting after the unit has been turned off.

However, if the unit is unplugged, the control

panel will reset to Hi (II) and will no longer

remember the previous mist output level setting.

Mist Control/ Humidity Level Control (See

Fig. 1 F2)

To raise or lower the humidity level, adjust the

fan to low or high mist output levels:

I / Lo = Low mist output

II / HI = High mist output

NOTE: Mist output level setting alternates Hi(II)

to Lo(I) with one touch to the Mist Control (F2)

on the Control Panel (F).

Control Panel

The control panel has a humidity indicator light

and will show differing colours as follows:

Amber = Low humidity. (Below 50%

Relative Humidity Level)

Green = Comfort Humidity Level (About

50% Relative Humidity Level)

Blue = High humidity. (Above 50%

Relative Humidity Level)

Screen flickers = water level in basin is low,

refill tanks

NOTE: The recommended humidity level is

between 40% - 50%.

AUTO SAFETY SHUT OFF

This Ultrasonic Humidifier has two built in safety

devices:

1. When the water level in the basin is low, the

transducer will automatically shut off. Refill

the tanks as instructed in "Operating

Instructions" to operate the humidifier again.

2. When the Mist Channel is not positioned correctly

on the base, the fan and Transducer will

automatically shut off and the Control Panel

screen will flicker. Remove and replace the

Mist Channel to ensure proper fit.

FILTER USE

The Water filters are used to retain minerals in

your water and to provide clean moisture. The

filter life is determined by the average daily use

of your humidifier and the water hardness in

your area. The harder the water, the greater the

amount of minerals in the water and more often

you will need to replace the filter. It is strongly

recommended that each filter is replaced every 2

months, (depending on use), or when white dust

is emitted from the unit.

1. Make sure the unit is turned off and

disconnect from the mains outlet. Remove

Water Tanks (M) and Mist Channel (B).

2. If replacing, remove the Filters (O) from the

base and dispose.

3. Remove the protective plastic bag from the new

filters. Soak filters thoroughly by immersing filters

in water for 5 minutes. Install the filters into

the base.

4. Fill the water tanks with clean, cool tap water and

replace it in the base.Wait 15 minutes for water to

pass through the filters before turning on the unit.

The 15 minute wait is necessary to ensure that

the filters are properly saturated and the water is

at its optimal level for best performance.

CARE AND CLEANING

Humidifiers provide comfort by adding moisture

to dry, heated indoor air. To get the most benefit

from the humidifier and to avoid product misuse,

follow all instructions carefully, specifically the

operation, care and maintenance guidelines.

Please note this is an electrical appliance and

requires attention when in use.

Cleaning your humidifier every one or two weeks,

depending on the water conditions is important

in order to maintain efficient, healthy, odour-free

operation. Water quality varies widely and,

combined with build-up of mineral scale in your

humidifier, may under certain conditions promote

the growth of micro-organisms in the water tank.

Before cleaning, Please note the following:

• DO NOT use soap, detergents, abrasives,

gasoline, glass or furniture polish, or boiling water

to clean any part of your Ultrasonic Humidifier.

These will interfere with the proper operation

of your unit and may affect its appearance.

• DO NOT use sharp or metal objects to clean

mineral deposits in the reservoir. Contact with

sharp objects can result in damage to the plastic.

• Mineral deposits should be soaked for up to

20 minutes in plain vinegar and water to

help with their removal.

• DO NOT clean any part of your humidifier in

the dishwasher.

Daily maintenance:

1. Before cleaning, switch off the unit and unplug

the unit from the electrical outlet.

BU4000I05M1 V.qxd 4/9/05 14:11 Page 7

Ocena

Więcej o tej instrukcji

Rozumiemy, że miło jest mieć papierową instrukcję obsługi Bionaire BU4000 Nawilżacz. Zawsze możesz pobrać instrukcję z naszej strony internetowej i wydrukować ją samodzielnie. Jeśli chcesz otrzymać oryginalną instrukcję, zalecamy skontaktowanie się z Bionaire. Być może będą w stanie dostarczyć oryginalną instrukcję. Szukasz instrukcji swojego Bionaire BU4000 Nawilżacz w innym języku? Wybierz preferowany język na naszej stronie głównej i wyszukaj numer modelu, aby sprawdzić, czy jest on dostępny.

Dane techniczne

Wszystkie podręczniki dla Bionaire Nawilżacze
Więcej podręczników Nawilżacze

Często zadawane pytania dotyczące Bionaire BU4000 Nawilżacz

Nasz zespół wyszukuje przydatne informacje na temat produktu i udziela odpowiedzi na często zadawane pytania. Jeśli znajdziesz nieścisłości lub błędy w naszych odpowiedziach na pytania, poinformuj nas o tym przy pomocy naszego formularza kontaktowego.

Produkty powiązane

Instrukcja

Bionaire BU3000 Nawilżacz

Instrukcja

Bionaire BWM5075C Nawilżacz

Instrukcja

Bionaire BWM401 Nawilżacz

Instrukcja

Bionaire BU7500 Nawilżacz

Instrukcja

Bionaire BU7000 Nawilżacz

Instrukcja

Bionaire BUH003X Nawilżacz

Instrukcja

Bionaire BWM5075 Nawilżacz

Instrukcja

Bionaire BWM001X Nawilżacz

Powiązane kategorie